Processor Expert SoftwareのトピックRe: (Processor Expert)How to set pull-high/low for SCI in S12ZCA?

(Processor Expert)How to set pull-high/low for SCI in S12ZCA?

aaronlee — Thu, 11 Apr 2019 08:56:52 GMT

Hi,

We are using S12ZVCA & CodeWarrier 11.0.1

How to set pull-high/low for SCI?

PERT=0x03; // SCI1(PT0, PT1) Enable Pull Resistor
PPST=0; // SCI1(PT0, PT1) Pull High

Best Regard,

Aaron

Re: (Processor Expert)How to set pull-high/low for SCI in S12ZCA?

dianabatrlova — Fri, 12 Apr 2019 11:58:39 GMT

Hi Aaron,

Could you try to use settings below?

I hope it helps.

Best Regards,

Diana

Re: (Processor Expert)How to set pull-high/low for SCI in S12ZCA?

aaronlee — Tue, 16 Apr 2019 05:18:52 GMT

Hi Diana,

What version is your CodeWarrier?

We are using S12ZVCA & CodeWarrier 11.0.1

Best Regards,

Aaron

Re: (Processor Expert)How to set pull-high/low for SCI in S12ZCA?

dianabatrlova — Tue, 23 Apr 2019 09:00:51 GMT

Hello Aaron,

I would like to apologize for the delay.

I have used the same version of CW, but a different component.

However, if the SCI transmitter feature is enabled the effect on enabled pull device is forced off.

Only the SCI receiver can be controlled by PER/PPS.

But the pull-up functionality is not available in the AS1 component. So, you can set it in the user code section.

Best Regards,

Diana

Re: (Processor Expert)How to set pull-high/low for SCI in S12ZCA?

aaronlee — Fri, 26 Apr 2019 06:20:37 GMT

Hi Diana,

Thanks for your reply.

Do you mean I need to add the following code by myself?

main(){
   .....
   PERT=0x03;
   PPST=0;
   .....
}

I have been try to install CodeWarrior v11.1, but the result same as v11.0.

Then, I try to use AsynchroMaster and AsynchroSlave, the result same as AsynchroSerial.

I could not find PULL RESISTOR as your screenshot.

Best Regards,

Aaron

Re: (Processor Expert)How to set pull-high/low for SCI in S12ZCA?

dianabatrlova — Fri, 26 Apr 2019 07:33:41 GMT

Hi Aaron,

Yes, that is what I mean (add that code by yourself).

The setting from my screenshot is available only in the init_SCI component.

Best Regards,

Diana