topic Re: Re: About s12ZVH clock configuration on CW10.6-PE in Processor Expert Software

About s12ZVH clock configuration on CW10.6-PE

Fan_xy — Mon, 16 Mar 2015 09:49:47 GMT

Hello,

I configure the Bus clock 32 MHZ, use internal clock , S12ZVH128 chips. CW 10.6 -PE

There is no error when build , while ,when debug, it show this :

Where is wrong ?

Thank you !

Re: About s12ZVH clock configuration on CW10.6-PE

marek_neuzil — Tue, 17 Mar 2015 06:49:23 GMT

Hello,

The crash of the application can be caused by many reasons (debugger settings, error in a driver/application code, target board/silicon connection and so on). Have you analyzed the application which part of the code (line) cause the error?

What target board and silicon are you using?

Could you send me the application for analysis, please?

Best Regards,

Marek Neuzil

Re: Re: About s12ZVH clock configuration on CW10.6-PE

trytohelp — Fri, 20 Mar 2015 09:43:35 GMT

Hi Marek,

I've reproduced the problem on my side too with a S12ZVML-MINIBRD.

I've reported the issue to P&E.

Attached a video showing the problem.

Pascal

Re: About s12ZVH clock configuration on CW10.6-PE

trytohelp — Tue, 24 Mar 2015 06:49:59 GMT

Hi,

I recieved feedback from P&E.

See below:

+++++++++++++++++++++++

OSBDM interface supports run control debug with devices operating at bus frequencies between 500khz and 24Mhz.

Hence, it will not be able to support talking to a device operating at 30Mhz bus frequency.

For debugging device operating at higher bus frequency rates, we recommend looking into using P&E's USB Universal Multilink hardware interface:

http://www.pemicro.com/products/product_viewDetails.cfm?product_id=15320137&menu_id=details

+++++++++++++++++++++++

Pascal

Re: About s12ZVH clock configuration on CW10.6-PE

marek_neuzil — Thu, 26 Mar 2015 10:09:35 GMT

Hi Pascal,

Thank you for the resolution of this issue.

Best Regards,

Marek Neuzil