PCF85263 RTC INTA flag issue

ohck — Wed, 06 Nov 2024 11:15:27 GMT

We're trying to use the pcf85263 rtc in stop-watch mode to generate a alarm and level signal on INTA, the INTA flag gets set correctly but we're unable to clear the INTA flag.

We're trying to clear the alarm by sending 0x00 to register 2Bh. Looking at the logic analyzer it gets ACKed and even set but INTA pin remains high.

Our config is as following description(also shown in the rtc.py file):

Config:

Read 0x28 register to verify correct rtcm mode TEST USE

Disable battery switch 0x26 register 0x10 data

Set INTA pin mode 0x27 register 0x10 data

Enable stop bit 0x2E register 0x01 data

Set rtcm mode and more to 0x28 register 0x97 data

Battery switch disable 0x29 register 0x90 data

Set minutes to 0x02 register 0x00 data

Set minutes alarm to 0x09 register 0x02 data

Enable minutes (SW control) 0x10 register 0x02 data

Clear stop bit 0x2E register

After business logic:

Clear flag 0x2B register

Apart from not being able to get the INTA pin down everything seems to work.

Question:

Is there something missing or are we doing something wrong? Clearing the INTA flag should set the INTA pin low right?

Thank you in advance

Re: PCF85263 RTC INTA flag issue

TomasVaverka — Wed, 06 Nov 2024 12:59:20 GMT

Hi,

I am not sure about this line in your code:

self.__write_data(bytearray([0x27]), bytearray([0x10]))

Please try to modify it to:

self.__write_data(bytearray([0x27]), bytearray([0x02]))

BRs, Tomas

topic Re: PCF85263 RTC INTA flag issue in Other NXP Products

PCF85263 RTC INTA flag issue

Re: PCF85263 RTC INTA flag issue