LPUART6 TX(high)/RX(low) all the time in iMX93(9332)

sibingl — Wed, 11 Sep 2024 06:34:01 GMT

iMX93(9332 soc), pinmux the gpio_io04 & gpio_io05 as LPUART6_TX & LPUART6_RX.

dts:

&lpuart6 {

pinctrl-names = "default";

pinctrl-0 = <&pinctrl_uart6>;

status = "okay";

};

pinctrl_uart6: uart6grp {

fsl,pin = <

MX93_PAD_GPIO_IO04__LPUART6_TX 0x31e

MX93_PAD_GPIO_IO05__LPUART6_RX 0x31e

};

when board power on, /dev/ttyLP5 dev created, but when I test the tx & rx pin， no signal received, and TX high, RX low all the time.

Plus, the BT dev connecting the LPUART6_TX & LPUART6_RX, no CTS&RTS pins exists.

#ls -l /dev/ttyLP*

crw------- 1 root tty 242, 0 Sep 10 18:00 /dev/ttyLP0

crw-rw---- 1 root dialout 242, 5 Sep 20 2023 /dev/ttyLP5

I changed the /dev/ttyLP5 group to be tty and I'm sure no gpios occupied by other devs.

Whicherver the termios app(read & write) or stty -F(cat & echo), the /dev/ttyLP5 attr can be saved and succedd to open /dev/ttyLP5, but no signal received by testing the RX&TX pins all the time.

Pls help me out of it or give me some hints or reference doc, Thx

Re: LPUART6 TX(high)/RX(low) all the time in iMX93(9332)

Manuel_Salas — Wed, 11 Sep 2024 19:05:26 GMT

Hello @sibingl

I hope you are doing well.

This behavior is expected, because the driver needs the CTS and RTS "definitions".

You can solve adding the fsl,dte-mode:

&lpuart6 { compatible = "fsl,imx93-lpuart", "fsl,imx8ulp-lpuart", "fsl,imx7ulp-lpuart", "fsl,dte-mode"; pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart6>; status = "okay"; }; pinctrl_uart6: uart6grp { fsl,pins = < MX93_PAD_GPIO_IO04__LPUART6_TX 0x31e MX93_PAD_GPIO_IO05__LPUART6_RX 0x31e >; };

Then, you will be able to get data from the TX signal:

Remember the default speed is 9800 BPS.

Best regards,

Salas.

topic Re: LPUART6 TX(high)/RX(low) all the time in iMX93(9332) in Other NXP Products

LPUART6 TX(high)/RX(low) all the time in iMX93(9332)

Re: LPUART6 TX(high)/RX(low) all the time in iMX93(9332)