Other NXP ProductsのトピックRe: MMPF0100F6ANES

MMPF0100F6ANES

RamakrishnaC — Fri, 21 Jun 2024 09:15:20 GMT

HI Team,

MMPF0100F6ANES, In this part i am not using the VIN1, VIN2, SW2 and SW4. as per NXP reference document need connect >3.4V to VIN1 & VIN2 without using the outputs. So shall i connect VGEN6 output(3V) to VIN1 & VIN2?

Please confirm.

Thanks.

Re: MMPF0100F6ANES

diazmarin09 — Mon, 24 Jun 2024 18:40:24 GMT

Hello RamakrishnaC,

I hope all is great with you. Thank you for using the NXP communities.

Correct. Based on the document attached, if VIN1 and VIN2 are not used, they must be connected to the output of a regulator with voltage <3.4V and <3.6V respectively.

I hope this information helps.

Regards,

David

Re: MMPF0100F6ANES

RamakrishnaC — Thu, 27 Jun 2024 06:14:39 GMT

Hi David,

Thank you.

My queation is shall i connecet the other voltage regulator output to VIN1 & VIN2?

Please review and check my scheamtic complete PMIC configuration and share your feedback details.

Thank you.

Re: MMPF0100F6ANES

diazmarin09 — Thu, 27 Jun 2024 16:06:26 GMT

Hello RamakrishnaC,

Once again, thank you for using the NXP community.

Correct, as long as the output of a regulator is <3.4V and <3.6V respectively.

Your schematic seems correct to me.

Regards,

David

Re: MMPF0100F6ANES

RamakrishnaC — Thu, 27 Jun 2024 16:54:31 GMT

Hi David,

Thank you.

And one more conformation needed.

Can i connect the VGEN6 output voltage to VIN1 & VIN2?

Please confirm.

Re: MMPF0100F6ANES

diazmarin09 — Thu, 27 Jun 2024 18:28:17 GMT

Hello RamakrishnaC,

Yes, you can. As long as VIN3 is supplied, you can connect the VGEN6 output to VIN1 and VIN2.

I hope this information helps.

Regards,

David