topic Re: display failure in Other NXP Products

display failure

kksun — Wed, 28 Jun 2023 07:00:14 GMT

Dear,

1.PTN3460BS is used by customers as eDP to LVDS, and LVDS display failure occurs when the machine is repeatedly switched on and off

2.When the LVDS display fails, the HPDRX level is low

Best Regards,

Re: display failure

JozefKozon — Wed, 28 Jun 2023 11:43:34 GMT

Dear Kaikai,

if the HPDRX is low, it means, the initialization has not completed.

After the failure, I would recommend to do a power-up reset, so the internal registers will be initialized. Please refer to the AN11489.

With Best Regards,

Jozef

Re: display failure

kksun — Thu, 29 Jun 2023 02:11:33 GMT

Dear Jozef,

1.When LVDS display failure, the internal output VDD(1V8) is 1.684V.

2.LVDS display failure also occurs after power up reset.

3.HPDRX first pulls up for 59ms followed by a sustained low level.

Re: display failure

kksun — Thu, 29 Jun 2023 05:46:42 GMT

Dear Jozef

What causes incomplete initialization?
We didn't find any anomalies in the power-on timing.
LVDS display failure, the internal output VDD(1V8) is 1.684V.

Best Regards,

Re: display failure

JozefKozon — Thu, 29 Jun 2023 08:12:50 GMT

Dear Kaikai,

if you have finished the power up sequence before you turn of the PTN3460BS. How quickly to do you turn-on and turn-off the machine? And how many times, do you turn-on and turn-off the machine before the fault happened?

Its possible, that the PTN3460BS is set to Deep power-saving state.

Please confirm how you have connected the PD_N pin. Please share your schematic with voltage levels and part values.

With Best Regards,

Jozef

Re: display failure

kksun — Thu, 29 Jun 2023 08:52:32 GMT

Dear Jozef

Pause between power on and power off for three to five seconds
We currently repeat the switch maneuver 25 times with 5 display failures
What causes the set deep power saving state?
Could you please provide similar documents for chip error data
Display failure,PD_ is high(>3V)Best Regards,
kaikai

Re: display failure

JozefKozon — Tue, 04 Jul 2023 05:28:36 GMT

Dear Kaikai,

I don't see a reason for the PTN3460 occasional fault behavior. I have contacted an application engineer dealing with PTN3460 components for an advice. So far I haven't received an answer from him. As soon as I receive one, I will definitely reply to you. Thank you for your patience.

With Best Regards,
Jozef

Re: display failure

JozefKozon — Tue, 11 Jul 2023 08:37:23 GMT

Dear Kaikai,

there is still no answer from the application engineer. I have just sent him a reminder. Hopefully he will answer me soon. Thank you for your patience.

With Best Regards,

Jozef

Re: display failure

JozefKozon — Wed, 12 Jul 2023 05:37:38 GMT

Dear Kaikai,

please try a recommendation from the application engineer.

DESCRIPTION

Please ask customer to remove R673 (0 hom) on board (PD_N pin only has 10Kohm pull-up), and test again to see whether issue can be resolved.

With Best Regards,

Jozef