topic Re: FS6510 Level Triggering at low level in Other NXP Products

FS6510 Level Triggering at low level

N123 — Thu, 10 Nov 2022 10:03:29 GMT

Hi,

Is it possible configure a low-level trigger on IO of FS6510 SBC for waking up?

We want to use level triggering but below a voltage.

For example, whenever IO5 receives a level lower than 5V, then it should wake up the system. (We don’t want to depend on edge triggering as we are unsure on rate of falling).

In case there is some documentation stating all register definitions, please share.

Re: FS6510 Level Triggering at low level

TomasVaverka — Thu, 10 Nov 2022 13:19:44 GMT

Hi Neetigya,

Yes, it is possible to achieve that by setting WU_IO5_1:0 bits to 0b10:

Valid high/low voltage: IO5 pin Voltage>2.6V = High, Voltage<2.1V = Low:

Best regards,

Tomas

Re: FS6510 Level Triggering at low level

N123 — Thu, 10 Nov 2022 13:38:05 GMT

Hi,

Thank you. Could you please share edge triggered data similar way? Like voltage levels and rate of rise and fall (as in 2nd screenshot)?

Re: FS6510 Level Triggering at low level

TomasVaverka — Fri, 11 Nov 2022 11:28:25 GMT

Hi Neetigya,

I do not have such data. I can only add an info about the deglitch time:

Meaning, if IO voltage < 2.1V and the duration is > 70us, then the device will wake up.

Best regards,

Tomas

Re: FS6510 Level Triggering at low level

N123 — Fri, 11 Nov 2022 11:30:08 GMT

Hi, Thank you very much.

We were asking regarding this time constraint only.