Other NXP ProductsのトピックRe: Basic simulation of NXP LDMOS device in Keysight ADS

Basic simulation of NXP LDMOS device in Keysight ADS

jmsebastian — Mon, 30 May 2022 12:48:11 GMT

Hi,

I am doing some basic simulation of AFT27S010N transistor in ADS and I have some questions.

First, I am simulating IV curves. This is the schematic:

With this schematic, after launching simulation, I get the following warning:

Is there something wrong in my schematic? How can I avoid such warning?

Ignoring this warning, I go on with simulation. IV curves seem to be ok. For Vdc = 28v and Vgs = 1.9v, I get Ids = 112mA, which is near the 90mA used along the datasheet.

After that, I use another schematic to get S(2,1). In this schematic I set Vds = 28v and Vgs = 1.9v.

The values for S(2,1) are just a few dB, far from the about 20 dB stated in the datasheet.

Is there something wrong with the setup of my simulation?

Any advice will be very welcome.

I have attached the workspace I am using.

Re: Basic simulation of NXP LDMOS device in Keysight ADS

wilsondavies — Tue, 31 May 2022 09:14:50 GMT

Thanks For sharing this valuable information. if you like food this article is only for you guys. Wendy’s is an American multinational chain of fast-food restaurants. Wendy’s is the third-largest hamburger fast-food chain in the country.

For More Info Check Here: Wendy’s Breakfast Menu 2022

Re: Basic simulation of NXP LDMOS device in Keysight ADS

diazmarin09 — Wed, 01 Jun 2022 21:35:01 GMT

Hello Sebastian,

I hope all is great with you.

In this case, I would like to recommend the following tutorials from the Keysight Design Software channel below:

How to Design an RF Power Amplifier,The Basics, Class A,AB and B

How to Design a Stable High Frequency Amplifier

GaN transistor amplifier has nothing special in design except of gate bias sequencing.

I hope this information helps.

Regards,

David