NFC中的主题 Re: NFC cockpit 15693 configuration

NFC cockpit 15693 configuration

tttttttcccc — Tue, 08 Sep 2020 08:41:38 GMT

Hi there,

I am trying to use NFC cockpit to set the configuration of NTAG 5 link to enable energy harvesting. Clev6630BM was used as the NFC reader.

I tried to read the configuration memory first by typing C0043D00 in the Tx data without flags and the flag is set 0x10. Below is the error I have got:

C0 = read_config

04 = manufacturer

3D = Block Address

00 = Block number

I am not sure how to set the flag and if the request command is incorrect.

Please advise. Thank you.

Re: NFC cockpit 15693 configuration

nxf58474 — Mon, 14 Sep 2020 17:26:04 GMT

Hi,

Hope you are doing well. You don't need to write the 04h byte, the NXP Manufacturer code is added by the tool. And you would need to set the flags as 02h. You can try with 02 C03D00 and it should work.

2020-09-14_11-50-08.png

You can check the 4th webinar of the NFC - NTAG® 5 SPOTLIGHTS. And I would recommend the NTAG 5 Cockpit, it is a specialized tool to work with the NTAG 5. (User Guides: NTAG 5 NFC Cockpit, NTAG 5 I2C Cockpit).

Hope this helps.

Best Regards,

Ricardo

Re: NFC cockpit 15693 configuration

alice1 — Wed, 16 Sep 2020 02:46:52 GMT

Is your problem solved? I encountered a similar problem, looking for a solution

Re: NFC cockpit 15693 configuration

tttttttcccc — Wed, 16 Sep 2020 05:19:52 GMT

Yes. It works fine without the manufacturer's code.

Re: NFC cockpit 15693 configuration

alice1 — Wed, 16 Sep 2020 05:32:59 GMT

my tag is CODE-SLIX

NFC reader is CLEV6630B

But I still can’t send data according to the above operation, I don't know where there is a problem