topic Re: MQX3.8+CW10.6 in MQX RTOS Training

MQX3.8+CW10.6

fjiewjg — Wed, 26 Mar 2025 07:24:02 GMT

Hello, I'm planning to conduct project development using the MQX operating system. The platform I'm using is CW10.6. I have downloaded the MQX 3.8 software package. However, I'm not sure how to create an engineering project and burn the program through MQX. I would appreciate it if you could provide some relevant routines and materials. Thank you.

Re: MQX3.8+CW10.6

danielchen — Thu, 27 Mar 2025 00:45:53 GMT

Hi @fjiewjg :

If you have the MQX software package, you can find the document inside the package such as getting started guider and reference manual, etc.. there is a folder named document.

Regards

Daniel

Re: MQX3.8+CW10.6

fjiewjg — Tue, 01 Apr 2025 08:24:30 GMT

Yes, I have seen this document. However, following the operation steps cannot be achieved. May I ask if the software package of MQX3.8 is compatible with CW10.6? Also, are there any examples or routines available for reference for learning?

Re: MQX3.8+CW10.6

danielchen — Tue, 01 Apr 2025 10:46:32 GMT

please check the release note, the supported toolchain is described.

Re: MQX3.8+CW10.6

fjiewjg — Wed, 02 Apr 2025 04:58:29 GMT

May I ask if there is an installation package for CW10.2? I need the 10.2 version. I haven't found it yet.

Re: MQX3.8+CW10.6

fjiewjg — Wed, 02 Apr 2025 06:28:11 GMT

When operating with the "FSL_MQX_in_CW_10_x" file and importing the "hello" project, this error occurs. Could you please tell me what's the reason?

Re: MQX3.8+CW10.6

fjiewjg — Wed, 02 Apr 2025 06:35:57 GMT

The simulator I'm using is PE_Multilink. How should I make the modification?

Re: MQX3.8+CW10.6

danielchen — Wed, 02 Apr 2025 10:55:16 GMT

This error maybe maybe related with Codewarrior version.

I would suggest you ask this question from Codewarrior community.

CodeWarrior - NXP Community

Regards

Daniel

Re: MQX3.8+CW10.6

fjiewjg — Mon, 14 Apr 2025 02:36:00 GMT

Hello, I have a question. In the MQX3.8 software package, the simulation tool used for the project in mqx/examples is USB. However, I am using Multilink. Could you please tell me how to change it?

Re: MQX3.8+CW10.6

danielchen — Mon, 14 Apr 2025 06:55:59 GMT

HI @fjiewjg

For Codewarrior IDE issues, I would suggest you post your question on codewarrior community.

CodeWarrior Development Tools - NXP Community

Regards

Daniel