topic How to initialize the module eTimer in MPC5604P in MPC5xxx

How to initialize the module eTimer in MPC5604P

ananan — Thu, 21 Sep 2017 06:08:44 GMT

these are my initialization of the module eTimer in the MPC5604.I want to use the module about the PWM function。but after enable the ENBL register ,the value of CNTR is not change.I do not kown how to use the module eTimer。please help me！My English is not good，forgive me。

ananan

Re: How to initialize the module eTimer in MPC5604P

PetrS — Thu, 21 Sep 2017 06:52:26 GMT

Hi,

you need to select Primary Count Source to be Peripheral clock, e.g.

ETIMER_1.CHANNEL[4].CTRL.B.PRISRC = 0x18;

If you want to have COMPx preloaded with COMPLDx then set the CCCTRL register

/* COMP1/COMP2 register is used when the counter is counting up.
Load COMP2 with CMPLD2 upon successful compare with the value in COMP2.
Load COMP1 with CMPLD1 upon successful compare with the value in COMP1. */
ETIMER_1.CHANNEL[4].CCCTRL.R = 0xA800;

BR, Petr

Re: How to initialize the module eTimer in MPC5604P

ananan — Thu, 21 Sep 2017 07:08:56 GMT

thank you very much！it is work！and I have a another quiestion 。how can I control the pulse

frequency and calculate from the COMP1、COMP2 and the PLL clock？

Re: How to initialize the module eTimer in MPC5604P

PetrS — Thu, 21 Sep 2017 08:46:47 GMT

The frequency of the PWM signal is calculated as

freq = MC_PLL_CLK / Prescaler / ( COMP1+1 + COMP2+1)

The eTimer channel's Prescaler value depends on setting CTRL[PRISRC].

BR, Petr