MPC5xxxのトピックRe: MPC5748G reset question

MPC5748G reset question

qiaodeng — Wed, 03 Aug 2016 15:08:06 GMT

When I was downloading program for MPC5748G, the power was cut off accidently. Now the MCU reset pin is always low level, and I can't download program anymore. The S32 design studio shows the window below:

Has the MCU been locked? What should I do to have access to MCU again?

Re: MPC5748G reset question

bdn — Wed, 03 Aug 2016 16:00:57 GMT

Hi qiaodeng,

please have a look at this thread: MPC5748G Flash Problem.

Regards,

Bernhard

Re: MPC5748G reset question

qiaodeng — Thu, 04 Aug 2016 03:15:43 GMT

Hi Bernhard,

Thanks for your help. I have tried the method you mentioned in the thread, and I got exactly the same problem as yours. I still can't revive my MCU. Have you resolved this problem?

Regards,

Qiao

Re: MPC5748G reset question

martin_kovar — Thu, 04 Aug 2016 06:19:20 GMT

Hi qiaodeng,

have you correctly configured Delay after reset in debug configuration? Recommended value is 250ms, but you can use longer time.

Regards,

Martin

Re: MPC5748G reset question

qiaodeng — Thu, 04 Aug 2016 06:50:16 GMT

Hi Martin,

I have configured the delay time as 1000ms, but it still doesn't work. Because the reset pin is always at low level, I think the chip may enter some kind of reset mode?

Regards,

Qiao

Re: MPC5748G reset question

martin_kovar — Thu, 04 Aug 2016 07:15:02 GMT

Hi Qiao,

yes, it seems it is the same problem which Bernhard had. Are you able to try it again with different microcontroller? Because when reset line is always low, it most probably indicates the micro is "dead".

Regards,

Martin

Re: MPC5748G reset question

qiaodeng — Thu, 04 Aug 2016 07:28:36 GMT

Hi Martin,

Another 5748G chip can be flashed successfully via JTAG. However I really hope to revive this "dead" chip because manufacturing another controller will cost a long time...

Regards,

Qiao

Re: MPC5748G reset question

bdn — Thu, 04 Aug 2016 07:33:29 GMT

Hi qiaodeng,

I could not revive the controller and had to buy another one. I know they are really hard to get.

I could buy one from element14/newark. As the page says, there is one more in stock of the BGA324 version:

MPC574XG-324DS - NXP - DAUGHTER BOARD, 32BIT MCU | Newark element14

This is the daughterboard with one MPC5748G sample.

Regards,

Bernhard

Re: MPC5748G reset question

KushalShahNXP — Mon, 08 Aug 2016 16:15:46 GMT

Hi bdn,

I don't know which daughter board you have. But if you go to nxp.com/MPC5748g you may find the parts available to order if you have daughter board and don't want to buy new one.

Thanks.

Re: MPC5748G reset question

bdn — Mon, 08 Aug 2016 18:34:53 GMT

Hi Deactivated user,

thank you for that advice. I needed the BGA324 package which was not available at that time.

Regards,

Bernhard