MPC5xxx中的主题 how to choose DMA request source?

how to choose DMA request source?

zhangk — Thu, 04 May 2023 03:10:53 GMT

hello everybody,Now,I am using this board to test uart，My configuration is :

PORT: pc8--TX PC9--rx LinFlexD_2

Baud rate: 38400

DMA Channel: 0

I want to get transmitted data through DMA to UART on terminal,so I have to config DMAMUX, which DMA request source should I choose?（this is my configuration）

look,this my board，The serial port and openSDA are the same port，Is it feasible to configure LinFlexD_2 to use DMA?

this is my peri_clock_gating function

Re: how to choose DMA request source?

PetrS — Thu, 04 May 2023 06:18:58 GMT

Hi,

only LINFlexD_0 and LINFlexD_1 support DMA

BR, Petr

Re: how to choose DMA request source?

zhangk — Thu, 04 May 2023 06:36:45 GMT

Oh!，thank you so much,I have decided to change the serial port LinFlex， If I use LinFlexD_0 or LinFlexD_1,which DMA request source should I choose?I looked at some examples, such as the MPC5775K, which use source 14, but I didn't find them in the manual

Re: how to choose DMA request source?

PetrS — Thu, 04 May 2023 07:02:07 GMT

HI,

as you can see from table 71-1 you posted, source number for DMAMUX setting is 29 in case of LINFlexD TX DMA request. For LINFlexD_0 you configure DMAMUX_0, for LINFlexD_1 configure DMAMUX_1.
This device includes two DMA request MUXes that allows up to 32 DMA request signals to be mapped to the first 16 DMA channels [DMA_CH0 - DMA_CH15] for DMACHMUX_0 and the last 16 DMA channels [DMA_CH16 - DMA_CH31] for DMACHMUX_1.

BR, Petr

Re: how to choose DMA request source?

zhangk — Thu, 04 May 2023 10:02:45 GMT

Thanks! I have changed the serial port configuration to LinflexD_1，But now there is a new problem，Every time I go into debugging，then click pause，It will be like this：

I think it's my DMA configuration that is wrong，this is my dma configuration

and this is AIP_INIT:

this is uart init

Finally, I configured peri_clock_gating

The main function is like this：

Am I missing any configuration?

Re: how to choose DMA request source?

PetrS — Fri, 05 May 2023 12:10:19 GMT

Hi,

the UARTCR is not properly configured, you have several writes to register.

BR, Petr

Re: how to choose DMA request source?

zhangk — Fri, 05 May 2023 12:23:42 GMT

Thank you so much!，I've solved it today，I referred to this this https://community.nxp.com/t5/MPC5xxx/MPC5746C-LINFlexD-1-DMARXE-DMATXE/m-p/879852