MPC5xxx中的主题 Re: MultiLink FX

MultiLink FX

NewStarter — Thu, 17 Feb 2022 01:06:37 GMT

Hi supportors,

Can S32 design studio IDE run with Jlink ? or only multilink supported?

MCU is MC33771 and MC5744P.

the board I'm using is RD33771-48VEVM.

BRs

KuoShu

Re: MultiLink FX

petervlna — Thu, 17 Feb 2022 09:12:50 GMT

Hello,

We only support in S32DS JLINK for ARMs and some PIC.

It is not supported for MPC5744P.

Best regards,

Peter

Re: MultiLink FX

NewStarter — Fri, 18 Feb 2022 08:28:02 GMT

Hi Peter,

Since S32DS only support ARM-based MCUs, why this offical website https://www.nxp.com/document/guide/get-started-with-the-rd33771-48vevm:GS-RD33771-48VEVM mentions I need to install S32DS and program MC5744 and MC33771 by Multilink FX?

would you help to clarify this?

BRs

KuoShu

Re: MultiLink FX

petervlna — Mon, 21 Feb 2022 07:31:57 GMT

Hello,

Since S32DS only support ARM-based MCUs

I am afraid there is misunderstanding. The S32DS supports MPC5744P debug for sure. but with PEMicro, or Lauternach debug. Not for Jlink.

And Jlink is available in S32DS only for ARM based processors.

So no Jlink for MPC57xx.

Best regards,

Peter

Re: MultiLink FX

NewStarter — Wed, 23 Feb 2022 02:53:25 GMT

ok, thanks Peter.

One more question, I bought this board https://www.nxp.com/design/designs/rd33771-48vevm-reference-design:RD33771-48VEVM

and it has two MCUs on it, one is MC33771 and the other is MPC5744P, would you help me to check how can I know these two MCUs already programmed in default status? (which pin I can probe from to confirm it's in operation condition?)

BRs

Re: MultiLink FX

petervlna — Thu, 24 Feb 2022 08:46:14 GMT

Hello,

I expect there is already programmed SW for both micors.

For sure it is for MC33771 by default.

Simply follow the Get started with the RD33771-48VEVM

Best regards,

Peter

Re: MultiLink FX

NewStarter — Fri, 25 Feb 2022 02:26:25 GMT

thanks Peter, I will try it.

BRs