topic Re: MPC5744DEVKIT UART1 by MBD in MPC5xxx

MPC5744DEVKIT UART1 by MBD

ykarata1 — Tue, 30 Mar 2021 11:48:53 GMT

Dear All,

I am trying to use UART1 on DEVKIT by Matlab Simulink. I have used UART0 and get data over that. But I need to communicate over UART1.

What I have done is:

1. I have converted UART Config to UART1 and its pins are PTD12 and PTD9.

I have connected my TX and RX cables on J3-02 and J3-04.

But I can not observe any data on RX. MCU should have transmitted "Hello World".

What I have done wrong? How can I correct?

Thanks.

Re: MPC5744DEVKIT UART1 by MBD

PetrS — Tue, 30 Mar 2021 13:16:50 GMT

Hi,

what is the board revision you have. For example on rev.E J3-02 and J3-04 are not connected to PD12 and PD9 by default, can be done via jumpers on J175 header. Refer to board's schematic.

BR, Petr

Re: MPC5744DEVKIT UART1 by MBD

ykarata1 — Tue, 30 Mar 2021 13:20:59 GMT

Dear @PetrS ,

We are using rev E board. As far as your statement, I understand that what I am doing is right. When I switch J175 Jumper it will work. Am I right?

Also where can we find that kind of information without opening a ticket?

Thansk.

Re: MPC5744DEVKIT UART1 by MBD

PetrS — Tue, 30 Mar 2021 19:15:19 GMT

Hi,

schematic is available on https://www.nxp.com/webapp/Download?colCode=SCH-29333-E
You should see output signal if you will measure right pin.

BR, Petr

Re: MPC5744DEVKIT UART1 by MBD

ykarata1 — Fri, 02 Apr 2021 11:31:27 GMT

Dear @PetrS ,

I could not handle that.

Can you help me understand my problem.

1. I am using sample model that NXP has given as sample that sends "Hello World". I have observed it works with UART0.

2. I have changed UART0 -> UART1 and have selected PTD12 and PTD9 for RX and TX pins.

3. Then I embedded the code.

4. I connected J175 so that; 1 and 5; 2 and 6 are shorted.

5. I put oscilloscope at the end of J3-4 (UART TX) and GND.

6. I could not observe data bits on the screen.

Why this is happening? What I am doing wrong?

Re: MPC5744DEVKIT UART1 by MBD

PetrS — Tue, 06 Apr 2021 11:57:11 GMT

Hi,

if there are jumpers on J175 then remove default connection (2-4,1-3) and place it to 4-6, 3-5 position.

BR, Petr

Re: MPC5744DEVKIT UART1 by MBD

Kavin_raj_mbd — Sat, 02 Dec 2023 19:02:25 GMT

Hi,

While Importing .xml in S32K design Studio 3.5, i am not able to open the project. Can anyone help me on this?

Thanks,