topic Re: Error with OpenSDA connection in MCUXpresso IDE

Error with OpenSDA connection

Flo2 — Mon, 08 Apr 2024 09:02:09 GMT

Hello,

I'm using the AFBR-S50LV85D-EK evaluation kit with MCUXpresso IDE v11.9.0

I did a lot of test with this board, reprogramming it with the SDA connector.

But since this morning, I cannot reprogram it, I've got the message in attached.

Any idea to help me please ?

Thank you

Re: Error with OpenSDA connection

Alice_Yang — Wed, 17 Apr 2024 08:17:20 GMT

Hello @Flo2

How about updating debug firmware to j-link?

Alice

Re: Error with OpenSDA connection

Flo2 — Wed, 17 Apr 2024 08:26:02 GMT

Hello Alice,

I don't have j-link debug probe. How can I proceed ?

Regards,

Re: Error with OpenSDA connection

Alice_Yang — Wed, 17 Apr 2024 09:52:31 GMT

Hello @Flo2

Sorry maybe you misunderstood me. I mean update the firmware of OpenSDA to J-link. No external J-link debugger needed.

Pay attention, if your system is win10. Please find a Win7 system PC to update.

Detail please refer to:

https://www.nxp.com/design/design-center/software/sensor-toolbox/opensda-serial-and-debug-adapter:OPENSDA#FRDM-KL46Z

Alice

Re: Error with OpenSDA connection

Flo2 — Wed, 17 Apr 2024 09:56:02 GMT

@Alice_Yang ,

My PC is win11, could it works ?

Re: Error with OpenSDA connection

Flo2 — Wed, 17 Apr 2024 13:30:08 GMT

@Alice_Yang,

What is the binary file I have to download ? OpenSDA V1 Bootloader ?

Where is the Segger JLink drivers in the download page?

Regards

Re: Error with OpenSDA connection

Alice_Yang — Thu, 18 Apr 2024 03:48:16 GMT

Hello @Flo2

Steps as below:

1) Find a win7 PC.

2) Pressing RST button of your board, plug-in USB with SDA.

3) There should be a "bootloader" Drive on your PC.

4) Copy and paste the Application binary file into the BOOTLOADER drive. I attach the binary file to you.

5)Un-plug and re-plug the USB cable from the SDA USB port WITHOUT keeping reset button pressed.

Alice

Re: Error with OpenSDA connection

Flo2 — Thu, 18 Apr 2024 06:44:15 GMT

Hello,

Will it works with a Windows 11 ?

Regards

Re: Error with OpenSDA connection

Alice_Yang — Fri, 19 Apr 2024 02:29:26 GMT

Hello @Flo2

Update firmware need based on Win7 system.

After updated, board can work on Win11.

If you really no Win7, can try this method:

https://mcuoneclipse.com/2018/04/10/recovering-opensda-boards-with-windows-10/

Alice