topic Re: After programming with J-Link, the program cannot auto run. in MCUXpresso IDE

After programming with J-Link, the program cannot auto run.

FanXH — Thu, 20 Oct 2022 13:21:18 GMT

I use MCUXpresso IDE v11.6.0 [Build 8187] [2022-07-13]

Jlink V7.66

After programming with J-Link, the program cannot auto run.I need to restart the development board manually.

Thank you!

Re: After programming with J-Link, the program cannot auto run.

jay_heng — Fri, 21 Oct 2022 02:32:39 GMT

What is your MCU target?

Re: After programming with J-Link, the program cannot auto run.

FanXH — Fri, 21 Oct 2022 02:35:51 GMT

衡哥好！！！

RT1061

Re: After programming with J-Link, the program cannot auto run.

FanXH — Fri, 21 Oct 2022 04:33:20 GMT

When I click "Program flash action using SEGGER J-Link probes", it execute

it should add a command "r" before "qc", it can auto run.

Re: After programming with J-Link, the program cannot auto run.

RaRo — Wed, 02 Nov 2022 14:42:17 GMT

Hello @FanXH,

Could you try out to wait a little bit if it runs by itself? Checking your issue, there was a situation related with the time it gets to run after program the flash of the board.

Also, could you please check out that the RESET pin of the J-Link programmer is connected to the RESET pin of the board? Are you using a custom board?

Regards, Raul

Re: After programming with J-Link, the program cannot auto run.

FanXH — Thu, 23 Mar 2023 09:19:24 GMT

Yes, it can runs by itself after a long time, it seem 10s.