https://community.nxp.com/t5/MCUXpresso-IDE/issue-with-LPC-Link2/m-p/1187136#M6402 <P>Hello ,</P> <P>It seems there is no issue with LPC-link2, you can use another debugger connect your board to test.</P> <P>How about debut other boards?</P> <P>And try to enter ISP mode of your board, erase all , then debug again.</P> <P>&nbsp;</P> <P>Regards,</P> <P>Alice</P> Mon, 23 Nov 2020 04:19:57 GMT Alice_Yang 2020-11-23T04:19:57Z https://community.nxp.com/t5/MCUXpresso-IDE/issue-with-LPC-Link2/m-p/1187008#M6401 <P><SPAN>I have attached a file to show all the steps I have followed and the error message that I received. When I posted the previous problem I got connected to serial port using Tera Term but now the cursor was blinking and no message that says LPC_OK.</SPAN></P> Sun, 22 Nov 2020 07:13:44 GMT https://community.nxp.com/t5/MCUXpresso-IDE/issue-with-LPC-Link2/m-p/1187008#M6401 eng4ever 2020-11-22T07:13:44Z https://community.nxp.com/t5/MCUXpresso-IDE/issue-with-LPC-Link2/m-p/1187136#M6402 <P>Hello ,</P> <P>It seems there is no issue with LPC-link2, you can use another debugger connect your board to test.</P> <P>How about debut other boards?</P> <P>And try to enter ISP mode of your board, erase all , then debug again.</P> <P>&nbsp;</P> <P>Regards,</P> <P>Alice</P> Mon, 23 Nov 2020 04:19:57 GMT https://community.nxp.com/t5/MCUXpresso-IDE/issue-with-LPC-Link2/m-p/1187136#M6402 Alice_Yang 2020-11-23T04:19:57Z