MCUXpresso IDEのトピックRe: Problem with debugging in MCUxpresso 11.0

Problem with debugging in MCUxpresso 11.0

martinkoehler — Tue, 02 Jul 2019 09:34:54 GMT

Hello and good morning,

I have just today started using the new MCUxpresso 11.0 and I am currently testing it. I have no success debugging my device even though it worked fine with 10.2.

- Windows 10 64 bit

- No CRP

- Error message (both on "suspend" command and setting breakpoint: "supend operation timeout"

- My devices uses a LPC1227

- I tried both LpcLink and LpcLink2 (CMSIS-DAP), both give the same error

- Obviously already restarted MCUxpresso and windows, repowered probe and device

Any sugestions what might have caused this error (and how to fix it)?

Best regards

Martin Koehler

Re: Problem with debugging in MCUxpresso 11.0

Alice_Yang — Wed, 03 Jul 2019 08:44:15 GMT

Hi Martin Koehler,

How about another simple project ?

Re: Problem with debugging in MCUxpresso 11.0

lpcxpresso_supp — Wed, 03 Jul 2019 09:41:08 GMT

Hi Martin,

I cannot offer an immediate answer to this - we test LPC1227 MCU/boards as part of our routine overnight testing.

Therefore, please can I ask you to:

Restart the IDE

Power cycle your board/probe

Select a new workspace

Create and debug a new (hello world) project

... and if this fails please attach a copy of the Debug Log for our investigation.

If this is a dev board, please can you confirm?

Yours,

MCUXpresso IDE Support

Re: Problem with debugging in MCUxpresso 11.0

dariuskellerman — Fri, 05 Jul 2019 13:26:16 GMT

Hi everyone,

I have the exact same problem with an LPC54608. Cannot suspend or set breakpoints. Worked fine (in this regard, not so much in others) with previous MCUXpresso versions.

The usual remedies (power cycle debugger, power cycle board, restart MCUXpresso) do not help.

Is there anything that you need from me/us to reproduce this issue?

Best regards,

Darius

Re: Problem with debugging in MCUxpresso 11.0

martinkoehler — Mon, 08 Jul 2019 06:23:27 GMT

Hi,

I have succeeded getting another build to run normally so I compared them (shoutout to WinMerge program) and found the problem. Now my old project also works. In the debugger settings the "non-stop mode" (in GDB debugger tab) was active. Deactivating it fixed the issue.

Re: Problem with debugging in MCUxpresso 11.0

lpcxpresso_supp — Mon, 08 Jul 2019 11:12:17 GMT

Hi Darius,

Please create and debug a new (hello world) project:

... and if this fails please attach a copy of the Debug Log for our investigation (Console -> Debug messages).

If this is a dev board, please can you confirm?

Yours,

MCUXpresso IDE Support

Re: Problem with debugging in MCUxpresso 11.0

dariuskellerman — Wed, 10 Jul 2019 04:43:43 GMT

Hello Martin,

this also worked for me. Thank you very much!

Re: Problem with debugging in MCUxpresso 11.0

dariuskellerman — Wed, 10 Jul 2019 04:45:37 GMT

Hi,

Martin Koehler's solution of deactivating non-stop mode does the trick for me, so this is solved from my side.

However, I'm wondering, does the non-stop mode even do anything with FreeRTOS? I somehow cannot imagine that it has any effect at all.