MCUXpresso IDE中的主题 Re: Error: Unable to configure core for probe index 1.

Error: Unable to configure core for probe index 1.

ricardovargas12 — Fri, 09 Feb 2018 20:09:14 GMT

Hello,

I am in need of assistance understanding this error. I am trying to debug the app_demo but am getting the following error:

Error: Unable to configure core for probe index 1.

Wire not connected

A bit of info:

Running this on windows 7 Enterprise, Using a OM40002 development board.

Thanks for the help!

Re: Error: Unable to configure core for probe index 1.

lpcxpresso_supp — Sun, 11 Feb 2018 11:30:59 GMT

Can you first of all confirm that you have jumpers installed on P7 and P8 on your LPC8N04 board to enable debug access? For more information see section 3.3, "Setting up the board for Development" of the User Manual, available from:

LPC8N04 Development Board for LPC8N04 MCU|NXP

Regards,

MCUXpresso IDE Support

Re: Error: Unable to configure core for probe index 1.

michalisantonio — Fri, 01 Jun 2018 07:27:18 GMT

I have the same issue with QN9080-DK! It was working fine but now i get the same error message! Please help! I have not changed jumbers from when received the board and was working i could program the board ok. Only once connected JP5 but now removed that jumber. How to do hard reset?

Re: Error: Unable to configure core for probe index 1.

arthurtremeau — Wed, 18 Jul 2018 12:50:30 GMT

Hi all,

Same issue with OM13093 board. I don't know how to fix it ...

Re: Error: Unable to configure core for probe index 1.

michalisantonio — Wed, 18 Jul 2018 13:51:02 GMT

Problem solved by press all buttons on board. One of them should work :smileyhappy: not necessarily the reset one

Re: Error: Unable to configure core for probe index 1.

arthurtremeau — Wed, 18 Jul 2018 14:08:17 GMT

None buttons works on OM13093... (RESET or ISP ENABLE)

And on debug probe parts there is no button...

Re: Error: Unable to configure core for probe index 1.

michalisantonio — Thu, 22 Nov 2018 12:18:01 GMT

soft erase flash using GUI flash tool for MCUXpresso IDE. Can also place a jumper on JP15, and reset the board, or power it on/off for QN9080DK.