topic Re: Where is support for MLK03Zx in Processor Expert Driver Suite V10.4? in MCUXpresso Config Tools

Where is support for MLK03Zx in Processor Expert Driver Suite V10.4?

mist — Wed, 06 Dec 2017 21:04:24 GMT

Where is support for MLK03Zx in Processor Expert Driver Suite V10.4? Support for this part seems to have been removed from earlier versions of PE. Now I see only MLK02Z, 04Z and 05Z under Kinetis "L" series..

Re: Where is support for MLK03Zx in Processor Expert Driver Suite V10.4?

Alice_Yang — Thu, 07 Dec 2017 06:46:27 GMT

Hello Mikael Stewart,

About the New kinetis products, PE, CW, KDS will not provide support .

New Kinetis device support can be found with MCUXpresso Software and tools :

MCUXpresso Software and Tools for Arm® Cortex®-M cores|NXP

Hope it helps

Have a great day,
TIC

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: Where is support for MLK03Zx in Processor Expert Driver Suite V10.4?

mist — Thu, 07 Dec 2017 19:29:54 GMT

Thank you for your quick response, but I have a similar problem with MCUXpresso as well.

When I select processor MKL03Z16VFK4 for a new project, it then says "MCU is not supported" when I go to select tools > peripherals.

It appears that I can only configure the clock structure and route hardware pins but there is no code generation for any of the peripheral modules?

Regards

Re: Where is support for MLK03Zx in Processor Expert Driver Suite V10.4?

Alice_Yang — Fri, 08 Dec 2017 03:49:38 GMT

Hello Mikael,

Please download the latest version MCUXpresso IDE v10.1.0,

MCUXpresso IDE|NXP

then download the latest SDK2.3 for your chip :

https://mcuxpresso.nxp.com/en/builder?uvid=67907

This MCUXpresso IDE has integrate the clock configure tool , so you needn't download the standalone MCUXpresso Config tool .

Hope it helps

Alice

Re: Where is support for MLK03Zx in Processor Expert Driver Suite V10.4?

mist — Tue, 12 Dec 2017 18:47:19 GMT

Hello

I have tried as you suggested with the full MCUXpresso IDE + SDK. It installed OK and I can create a project, but once again when I select the peripherals perspective it says "MCU is not supported" like in the standalone MCUXpresso config tool. Is it that support is now only to set up clocks and to multiplex pins with peripheral config support to be added with later version?

Regards

Re: Where is support for MLK03Zx in Processor Expert Driver Suite V10.4?

Alice_Yang — Mon, 18 Dec 2017 07:21:50 GMT

Hello Mikael,

Yes, the peripheral config support for kl03 will be release in later version.

About MCUXpresso Supported Devices please check this table :

https://community.nxp.com/docs/DOC-333073

Hope it helps

Alice