topic Re: Debug Failed while using QN9080 example application in MCUXpresso General

Debug Failed while using QN9080 example application

smittal2 — Thu, 21 Jun 2018 07:32:28 GMT

Hi,

I'm new to NXP. I'm working on QN9080 chip. I installed the SDK and MCUXpresso IDE following all instructions. However, when I tried to build and debug an example application, it gave me the following error:

Error in final launch sequence
Error: Unable to configure core for probe index 1.
Wire not connected

LinkServer has been terminated and will be restarted.
Please restart your debug session.
If the problem recurs, please power cycle your debug probe and restart MCUXpresso IDE.
Error: Unable to configure core for probe index 1.
Wire not connected

LinkServer has been terminated and will be restarted.
Please restart your debug session.
If the problem recurs, please power cycle your debug probe and restart MCUXpresso IDE.

Can someone please help me what to do to resolve this. I'm stuck.

Thanks!

Re: Debug Failed while using QN9080 example application

gerardo_rodriguez — Fri, 22 Jun 2018 19:44:38 GMT

Hello Sandeep Mittal,

Please take a look at the following threads and let me know if the solutions suggested there work for you:

Wire not connected on Q9080-DX LinkServer

qn908x Unable to configure core for probe index 1

Regards,

Gerardo

Re: Debug Failed while using QN9080 example application

smittal2 — Mon, 25 Jun 2018 18:50:05 GMT

Thanks Gerardo, it worked.