MCUXpresso General中的主题 LinkServer/LinkFLash problems with Dump command

LinkServer/LinkFLash problems with Dump command

mimlo — Tue, 10 Jun 2025 10:08:31 GMT

Hello,
I have a problem with a Save command from LinkServer:

Below you will find a screen from LinkFlash GUI tool from where I can execute Save command (which performs memory dump into a specified .bin file) which works correctly:

However, if I perform the same command from terminal as in the Commands section on the bottom of the picture above, I get a following error (bottom part of the picture below):

I copy pasted the command from LinkFlash to the terminal, I also checked for some invisible characters that could be copied along the way. There were none, string was proper.

Any ideas?

Best regards,
Michael

Re: LinkServer/LinkFLash problems with Dump command

mayliu1 — Wed, 11 Jun 2025 09:33:09 GMT

Hi @mimlo ,

Thank you so much for your interest in our products and for using our community.

I did a test for your question, I'm having the same problem as you.

Then I modify the save command as following, it works, Please try it.

I will also escalate your question internally.

Thanks for raising this issue.

Wish it helps you.
If you still have question about it, please kindly let me know.

Wish you a nice day!

Best Regards
MayLiu

Re: LinkServer/LinkFLash problems with Dump command

mimlo — Wed, 11 Jun 2025 13:33:41 GMT

Hi @mayliu1,
Thanks for this, did not think about trying to revert the arguments.
That worked for me as well, thanks!

Re: LinkServer/LinkFLash problems with Dump command

mayliu1 — Thu, 12 Jun 2025 01:57:28 GMT

You are welcome.