Debugging with no flash

mspenard603 — Mon, 22 Jun 2020 19:12:27 GMT

Hi All,

How do I properly debug with MCUxpresso and a J-Link on a iMXRT1062 without flashing first? I've unchecked "Load Image". But when I click Debug, and then Restart, I don't ever hit any breakpoint I set in startup_mimxrt1062.c's init code. My Jlink must not be syncing even though it's attached or something...?

Re: Debugging with no flash

FelipeGarcia — Fri, 26 Jun 2020 16:00:25 GMT

Hello Mike,

I recommend you to check this blog from a colleague Attaching to a Running Target with Segger J-Link, GDB and Eclipse | MCU on Eclipse

I hope this helps!

Best regards,

Felipe

-------------------------------------------------------------------------------

Note:

- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored.

Please open a new thread and refer to the closed one, if you have a related question at a later point in time.

------------------------------------------------------------------------------

MCUXpresso GeneralのトピックRe: Debugging with no flash

Debugging with no flash

Re: Debugging with no flash