MCUXpresso GeneralのトピックRe: IDE Debug Mode: Non Stop not available

IDE Debug Mode: Non Stop not available

shiv_aishwarya — Fri, 29 Mar 2019 10:13:53 GMT

I am currently evaluating MKV46F256 Tower Board and when I am importing any SDK Examples or creating new project. I am not able to see Non Stop Mode for Debug. I have read on forum that gdb server is not compatible with gdb non stop. How can we resolve this?

Re: IDE Debug Mode: Non Stop not available

Hui_Ma — Tue, 02 Apr 2019 02:37:28 GMT

Hi,

Please check below picture to update your MCUXpresso IDE software.

Have a great day,
Mike

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

Re: IDE Debug Mode: Non Stop not available

shiv_aishwarya — Wed, 03 Apr 2019 13:20:31 GMT

It looks like there are no updates

Re: IDE Debug Mode: Non Stop not available

Hui_Ma — Thu, 04 Apr 2019 03:02:36 GMT

Hi,

I don't meet your mentioned issue during test.

Please try to update your board OpenSDA firmware with latest P&E OpenSDA image.

You could download it from here.

Wish it helps.

Have a great day,
Mike

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

Re: IDE Debug Mode: Non Stop not available

shiv_aishwarya — Thu, 04 Apr 2019 12:38:38 GMT

It didnt work. I have PE Micro Multilink Universal also. Even with that same issue is happening.

Re: IDE Debug Mode: Non Stop not available

Hui_Ma — Thu, 04 Apr 2019 21:49:41 GMT

For I could not regenerate the same issue on site, I would recommend to update on board OpenSDA firmware with Segger J-Link firmware so far.

Please check If J-LINK works. Thanks.

Best regards

Mike

Re: IDE Debug Mode: Non Stop not available

lpcxpresso_supp — Sat, 06 Apr 2019 20:21:44 GMT

Debug sessions via P&E debug probes only support the use of all-stop debug mode (and not non-stop, which is only available when using a LinkServer debug connection, typically CMSIS-DAP). But this does not stop you from being able to debug with a P&E probe. What issue do you actually think you have?

Regards,

MCUXpresso IDE Support