MBDT for RADARのトピックCAN TX in S32R274

CAN TX in S32R274

ansonan — Tue, 27 Nov 2018 07:26:51 GMT

CAN TX in S32R274

I USE THE CAN at loopback mode ,BUT

always wait here

while (CAN_1.MCR.B.FRZACK & CAN_1.MCR.B.NOTRDY) {} /* Wait to clear */
/* Good practice: wait for FRZACK on freeze mode entry/exit */

the tx can't tx signal

and the rx can't receive the signal

Re: CAN TX in S32R274

ansonan — Wed, 28 Nov 2018 10:35:58 GMT

the flexcan always in the Freeze mode?

i don't konw why

Re: CAN TX in S32R274

iulianbulancea — Thu, 29 Nov 2018 12:33:43 GMT

Hello,

Here on the Model-Based Design for RADAR community we handle questions regarding our toolbox or other MATLAB related questions. I think your question is best suited for the S32 Design Studio community, so my advice is to ask it there (as I can not move it myself).

As an alternative you could open a ticket for technical support here (go to 'Go to Ticket').

Hope this helps,

Iulian.