topic Reset led toggling while deploying the project from mbdt in Model-Based Design Toolbox (MBDT)

Reset led toggling while deploying the project from mbdt

Vijay98 — Sun, 16 Jun 2024 19:10:13 GMT

Hello NXP team,

We are working in dio configuration using mbdt with S32K344 EVB Rev B1.

while deploying the code using matlab we are able to see the functionality working but after some time like 3 to 5 sec the board reset LED starts blinking continuously.

Unable to find the solution. Can anyone give me some solutions!

Attached the project folder with this, kindly do some needful.

Thanks & Regards

Esakki

@VaneB @Irina_Costachescu @Robin_Shen @Ganapathi_NASH_INDIA @Kavin_raj_mbd

Re: Reset led toggling while deploying the project from mbdt

Kavin_raj_mbd — Sun, 16 Jun 2024 19:48:02 GMT

Hi esakki,

I am also facing the same issue...

In s32k344 evb rev A it's working fine but in s32k344 evb rev B1 after flashing for 5 to 10 sec it's working fine after that reset led starts blinking continuously

If you find any solution kindly let me know... then any one resolved this issue let us know

Thanks & Regards

@VaneB @Irina_Costachescu @Robin_Shen

Re: Reset led toggling while deploying the project from mbdt

dragostoma — Mon, 17 Jun 2024 11:09:53 GMT

Hi, @Vijay98,

Thank you for your interest into Model-Based Design Toolbox for S32K3.

It looks like your evaluation board enters into a sequential reset state. Please review the following thread S32K3X4EVB-T172 with MBD which addresses the same issue.

Let us know if your problem persists.

Best regards,

Dragos