topic Programming S32K344EVB-T172 in Model-Based Design Toolbox (MBDT)

Programming S32K344EVB-T172

josejulianEEVAM — Fri, 14 Jul 2023 08:31:55 GMT

Good Morning,

I'm trying to load a sample program on the NXP S32K344EVB-T172 development board using model based design, the code builds it without problems, but it won't let me load it on the board.

Is it possible that it is because I am trying to do it through OPENSDA instead of using the JTAG?

Thanks

Re: Programming S32K344EVB-T172

georgevictor — Thu, 20 Jul 2023 07:57:59 GMT

Hi, @josejulianEEVAM ,

Runtime error 216 is usually prompted when the target of your application is not the same as the hardware target, so please check that you have selected the right Hardware Part (S32K344-Q172 in your case) in the model settings. The embedded OPENSDA debugger of the board that you are using should work just fine.

Please check the following thread: S32K3X4EVB-T172, where you can find an extended answer to your problem.

Please let us know if this helped you.

Cheers,

Victor

Re: Programming S32K344EVB-T172

josejulianEEVAM — Fri, 28 Jul 2023 07:49:13 GMT

Hello, we have followed the steps you have told us but we have not been able to solve the error.
From the S32 design studio environment you can program directly, but we would like to do it from Simulink.
This are the steps followed in two examples, one using Tresos and the other using S32 design studio.

1. Example s32k3xx_dio_ebt:

In this example, I choose the S32K344EVB-Q172 electronic board:

Select the way to download the card as well

If I try to enter the configuration of a block I get the following message:

And if I try to flash the ECU, this is the diagnostic output -> s32k3xx_dio_ebt_Diagnostic.

2. Example s32k3xx_dio_s32ct:

In this example, I choose the S32K344EVB-Q172 electronic board:

Select the way to download the card as well

If I try to enter the configuration of a block I get the following message:

And if I try to flash the ECU, this is the diagnostic output -> s32k3xx_dio_s32ct_Diagnostic.

I am setting the default jumpers on the electronic board, do I have to change them?

Thanks,

Re: Programming S32K344EVB-T172

Nikunj_Patel — Sat, 11 Nov 2023 09:28:27 GMT

I am facing the same issue. Is the issue resolved @josejulianEEVAM ?

Re: Programming S32K344EVB-T172

georgevictor — Mon, 04 Dec 2023 14:00:52 GMT

Hi, @josejulianEEVAM,

The issue you are encountering may be related to the Windows path limitation. Review the following thread which addresses a similar issue.

Best regards,

Victor