problem with PIL simulation on NXPs32k144 evb

pierpaolo_dini — Thu, 18 May 2023 17:10:06 GMT

I encountering issues with concretize PIL procedure.

I face the following error in simulink

Cannot perform PIL simulation for "Esempio_0". Configuration parameters for this model do not support these connectivity configurations: IBIS_AMI, Arduino Board, Texas Instruments Code Composer Studio (IDE), Texas Instruments Code Composer Studio (TCP/IP), Texas Instruments Code Composer Studio (Serial), s32k_pil PIL, s32k_as_pil PIL Update configuration parameters or create a supported connectivity configuration. For more information, see Help Center.

i am sure that all the setup oprions are right (solver, settings i configure the HW implementation, th target block is right...), but i dont know why i face this error.

Its strange that if i build the code through the embedded coder app i face no problems in flashing the evb.

With harnest and SIL/PIL test apps instead i have such issue.

Can some one help me?

Thanks in advance

Re: problem with PIL simulation on NXPs32k144 evb

pierpaolo_dini — Fri, 19 May 2023 10:34:21 GMT

No one from technical support of NXP is able to provide solution or at least suggestion for workaround??!!

Re: problem with PIL simulation on NXPs32k144 evb

pierpaolo_dini — Sat, 20 May 2023 08:56:46 GMT

@paulvlase

i remember you help me with another issue, so i invoke you.

Can you suggest something to do?

Thanks in advance.

topic problem with PIL simulation on NXPs32k144 evb in Model-Based Design Toolbox (MBDT)

problem with PIL simulation on NXPs32k144 evb

Re: problem with PIL simulation on NXPs32k144 evb

Re: problem with PIL simulation on NXPs32k144 evb