Model-Based Design Toolbox (MBDT)中的主题 Re: How to drive S32K144EVB correctly In Matlab simulation environment

How to drive S32K144EVB correctly In Matlab simulation environment

chen2021 — Wed, 21 Jul 2021 09:00:10 GMT

Hello

In Matlab simulation environment.
I plan to use microUSB to update the model of S32K144EVB.
I updated a few examples,and there are no errors in the diagnostic viewer.
But EVB is unexecuted the model.
Could you give me some instructions? please

Two target connection settings are used(attachment：1.GPIO LED Blink(COM9).PNG & 2.GPIO LED Blink (OPEN SDA).PNG)
Installed the driver(attachment：3.DRIVER.PNG)
EVB appearance(attachment 4：.EVB.jpg)

Re: How to drive S32K144EVB correctly In Matlab simulation environment

mariuslucianand — Thu, 22 Jul 2021 18:48:07 GMT

Hello @chen2021 ,

Can you please check if the Download Code after Build option is checked?

Hope this helps,

Marius

Re: How to drive S32K144EVB correctly In Matlab simulation environment

chen2021 — Fri, 23 Jul 2021 09:30:22 GMT

@mariuslucianand

Hello Marius

Thanks for your reply.

Yes, it has been checked, but still unable to successfully update the model to EVB.

Setup screenshot as attachment

Re: How to drive S32K144EVB correctly In Matlab simulation environment

mariuslucianand — Thu, 05 Aug 2021 11:05:48 GMT

Hello @chen2021 ,

Can you please try to copy paste manually the .mot file form the generate folder to the mounted disk drive of the board? Maybe the OpenSDA needs an update on the board as described here https://community.nxp.com/t5/S32-Design-Studio-Knowledge-Base/HOWTO-Update-OpenSDA-Firmware-on-EVB/ta-p/1111067

Hope this helps,

Marius