topic Re: the Parameter calculation does not match in Model-Based Design Toolbox (MBDT)

the Parameter calculation does not match

董培董 — Mon, 21 Sep 2020 10:41:43 GMT

hi ,

When calculating the parameters of the observer, if the motor and electrical parameters are exactly the same, according to the method in the document(MC9S12ZVMMCLUG), the result calculated by MATLAB is different from the result calculated by MCAT. Is that accurate?The picture is as follows:

I want to get your help ,thank you very much!!!

Re: the Parameter calculation does not match

mariuslucianand — Tue, 22 Sep 2020 13:23:02 GMT

@marekmusak , can you please comment on this?

Thank you,

Marius

Re: the Parameter calculation does not match

nofake_drstrang — Fri, 25 Sep 2020 14:45:03 GMT

hi @董培董 ,

one question please:

do you use the example :

"\NXP_MBDToolbox_S12ZVMx\S12ZVM_Examples\s12zvm\mc\PMSM_Demo\PMSM_ClosedLoop"

of the new toolbox version 1.4

thanks in advance!

Best regards.

Re: the Parameter calculation does not match

董培董 — Sun, 27 Sep 2020 00:24:02 GMT

Hi, The soft version is as follows,and the FREEMASTER is 3.0,I hope I can get help,thank you very much

Re: the Parameter calculation does not match

Bark_8 — Wed, 07 Oct 2020 10:34:09 GMT

Thanks for this info

Re: the Parameter calculation does not match

Bark_8 — Wed, 07 Oct 2020 10:35:30 GMT

thanks