Model-Based Design Toolbox (MBDT)のトピックDears，how can i use multilink download code with Matlab Sumilink.

Dears，how can i use multilink download code with Matlab Sumilink.

Tommy_Liu — Thu, 25 Jun 2020 09:13:21 GMT

Dears

now I can download code to EVB32K board use Matlab Sumilink.

But i had a question. if I design a prototype board by myself, don't use the EVB32K. how can I configure the debugger, such as: P&E Multilink or JLink? where can I do the debugger change.

Many thanks.

Re: Dears，how can i use multilink download code with Matlab Sumilink.

mariuslucianand — Thu, 25 Jun 2020 11:52:30 GMT

Hello Tommy.Liu‌,

Unfortunately, we do not support flashing the board from Simulink using P&E Multilink or JLink.

But.

Instead of using the OpenSDA you can use the RappId Bootloader alternative. This implies flashing once the bootloader using Jtag and then using the Serial for deploying the generated code directly from Simulink on the board.

Since the compiling process generates the .elf file, another option would be to flash the generated .elf file using S32DS after the code has been generated and built.

Hope this helps,

Marius

Re: Dears，how can i use multilink download code with Matlab Sumilink.

Tommy_Liu — Sat, 27 Jun 2020 07:13:40 GMT

Dear Marius-lucian Andrei

Many thanks your guide！