topic Re: Unable to use interrupts inside the PIL simulation block in Model-Based Design Toolbox (MBDT)

Unable to use interrupts inside the PIL simulation block

manujagrawal — Tue, 02 Apr 2019 19:35:17 GMT

Hello,

I am new to using the MDBT toolbox for S32K144 on matlab for creating applications. I am facing difficulties in using interrupt routines inside the PIL model block (which contains the code to be executed on the microcontroller). Here are the screenshots of my model. I am trying to toggle a LED on UART transmission complete.

Top Model

PIL Block

The error which I get

The same error is reported even for any other interrupt I have tried to create. Seems like I am unaware of the methodology of using interrupts in PIL simulaiton.

Step size for both models is same (0.01 Sec)

To sum up, I want my embedded system to partially run on PC to design and tune my control algorithm while also been connected to microcontroller for sensor interfacing (which uses interrupts; for data acquisition and actuation).

I will highly appreciate any help on this issue.

dumitru-daniel.popa‌ constantinrazvan.chivu‌ b55689‌

Re: Unable to use interrupts inside the PIL simulation block

13226508 — Wed, 17 Apr 2019 05:12:55 GMT

Hi，

I have encountered the same problem with you. Have you solved it?

Re: Unable to use interrupts inside the PIL simulation block

manujagrawal — Wed, 17 Apr 2019 18:20:51 GMT

Hi Yang, I am still waiting for a reply on this issue.

Re: Unable to use interrupts inside the PIL simulation block

Daniel_Popa — Fri, 19 Apr 2019 05:37:39 GMT

Hello all,

We are currently looking into this issue. We were able to reproduce the issue and we are trying to understand the root cause.

Best regards,

Daniel