topic Re: the eTimer module configuration in Model-Based Design Toolbox (MBDT)

the eTimer module configuration

hjhjhj — Sun, 10 Dec 2017 09:39:04 GMT

Hi Daniel,

I try to configure the eTimer module to read more input pins,such as A4,A5,A6,A7,A8,F0 and D14.But only the input pin A0 is availble.It's possible that there's some problem in my configuration.Can you help me find it?The HW I used is MPC5744P DevKit.

Thanks!

Re: the eTimer module configuration

Daniel_Popa — Mon, 11 Dec 2017 08:08:09 GMT

Hi hjhjhj‌

We are looking into this. Stay tuned - we will update soon!

Thank you!

Daniel

Re: the eTimer module configuration

mariuslucianand — Tue, 12 Dec 2017 15:55:15 GMT

Hello hjhjhj‌,

Let's try like this: please replace in the {Path where you installed the toolbox}\mbdtbx_pnt\src\c_library the .c attached file (an advice would be to rename the existing one and keep it in case the one provided is not ok) and then try to test your model or the one attached.
I'm looking for your response to see if this worked or not.

Hope that helps,

Marius

Re: the eTimer module configuration

hjhjhj — Sat, 16 Dec 2017 22:08:07 GMT

Hello Marius，

Sorry for delay.The model attached work,but the pins A0,F0,D14,A4 always work at the same time and the any of pins A5,A6,A7,A8 affects the four pins A0,F0,D14,A4 .Is there any solutions for this.

Thanks!