topic MBDT code generation problem in Model-Based Design Toolbox (MBDT)

MBDT code generation problem

jiangfeng — Tue, 11 Jul 2017 07:49:28 GMT

When I do code generation in the MBDT, [ “C:/Freescle/"CW" is not the internal or external command] appears

What's wrong with it?

Daniel_Popa — Tue, 11 Jul 2017 08:25:26 GMT

It looks like your operation system does not take into consideration the paths that contains spaces.

You may even reinstall the CW IDE in a path without any spaces or you could enable the 8dot3 mode on that partition.

Hope it helps!

Daniel

jiangfeng — Fri, 14 Jul 2017 02:53:39 GMT

Hi，Daniel

I have solve the problem by your suggestion, thank you very much!!

在 2017-07-11 16:26:10，"dumitru-daniel.popa" <admin@community.nxp.com> 写道：

NXP Community

You have been mentioned

by dumitru-daniel.popain Re: MBDT code generation problem in NXP Community - View dumitru-daniel.popa's reference to you

Hi Jiang Feng,

It looks like your operation system does not take into consideration the paths that contains spaces.

You may even reinstall the CW IDE in a path without any spaces or you could enable the 8dot3 mode on that partition.

Hope it helps!

Daniel

Participate in the conversation by replying to this email

This email was sent by NXP Community because you are a registered user.

You may unsubscribe instantly from NXP Community, or adjust email frequency in your email preferences