LPCXpresso IDEのトピックRe: debuging and blue screen

debuging and blue screen

maciek001 — Fri, 21 Apr 2017 14:18:05 GMT

Hi! I have problem with LPCxpresso and MCUXpresso. I have lpcxpresso 1347 board. When I try to debug project my PC have blue screen. Probably I have problem with drivers. Wind 7 professional 64-bit SP1. Any solutions?

Re: debuging and blue screen

lpcxpresso_supp — Tue, 25 Apr 2017 13:52:14 GMT

I am afraid that we are not aware of any issues of this form. Thus I'm not sure what we can suggest to help. But at what point do you actually encounter the bluescreen? For instance, can you manually boot the LPC-Link(1) debug probe successfully?

https://community.nxp.com/message/630541

Regards,

LPCXpresso Support

Re: debuging and blue screen

maciek001 — Fri, 28 Apr 2017 18:36:31 GMT

Dear Support,

No bluescreen -> https://www.youtube.com/watch?v=vMKmWdgHD1Q

With bluescreen -> https://www.youtube.com/watch?v=ixwXr8sWNbI

2017-04-25 15:52 GMT+02:00 lpcxpresso_support <admin@community.nxp.com>:

NXP Community
<https://community.freescale.com/resources/statics/1000/35400-NXP-Community-Email-banner-600x75.jpg>
Re: debuging and blue screen
reply from LPCX support
<https://community.nxp.com/people/lpcxpresso_support?et=watches.email.thread>
in LPCXpresso IDE - View the full discussion
<https://community.nxp.com/message/899838?commentID=899838&et=watches.email.thread#comment-899838>

Re: debuging and blue screen

lpcxpresso_supp — Tue, 02 May 2017 08:54:58 GMT

So you appear to be using the GUI flash programmer, rather than debugging. Does debugging, using the Quickstart Panel debug button work correctly?

To be honest, I'm still not sure what else to suggest. It might be worth booting your probe manually and then using the command line GUI flash programmer and seeing if you get any more error information:

Booting LPC-Link

[Also check out the troubleshooting section of the above FAQ]

https://community.nxp.com/message/630785

Regards,

LPCXpresso Support

Re: debuging and blue screen

maciek001 — Thu, 11 May 2017 07:41:42 GMT

It's a miracle. My debuger is running propertly now. I Run another debug probe (LPCXpresso with LPC11U14) and it was run correctly. Next I run previous board (LPC1347). I have no problem! Thanks for your interest in my problem.