topic LPC not programming correctly in LPC Microcontrollers

LPC not programming correctly

randylee — Tue, 11 Jul 2023 17:49:28 GMT

I've got some LPC1751 parts that aren't programming correctly. We're programming them with a J-link using the hex files. They go through all the hoops of programming (including verification) but hang as they start up doing nothing at all. The good parts, using the same procedures and things, work fine. The bad parts are being sourced in China, the good ones from US disty channels.

Attached are pictures of the top side of the parts. I can't see what issue there would be here...

Anyone from NXP willing to take a stab at this?

Re: LPC not programming correctly

ZhangJennie — Wed, 12 Jul 2023 03:07:00 GMT

Hi randylee

If your part is not purchased from official disty, we can't guarentee if the part is real or counterfeit. We only support part from official disty.

Thanks,

Jun Zhang

Re: LPC not programming correctly

randylee — Wed, 12 Jul 2023 21:05:44 GMT

This was China disty from what the board CM has to tell about it. Of course, it's hard to tell exactly at this distance.

Re: LPC not programming correctly

ZhangJennie — Thu, 13 Jul 2023 03:48:11 GMT

We can find NXP LPC17xx part distributor here

https://www.nxp.com/part/LPC1751FBD80#/

Click on Available Distributors

Thanks,

Jun Zhang

Re: LPC not programming correctly

randylee — Thu, 13 Jul 2023 12:52:36 GMT

If we shipped someone at NXP the bad parts, can NXP tell if those are real or not? Would that give NXP any data that is of interest to you?