About PRINT of .5.0_LPCXpresso54608

bdbz — Thu, 11 Jul 2019 05:21:35 GMT

Now，i'm working on lpc54608.I used the lpcxpresso54608 of SDK2.5.0_LPCXpresso54608 code（usart_polling project）.i can tx and rx to the com software.but PRINT can work.do you have any sugesst？thanks ！

Re: About PRINT of .5.0_LPCXpresso54608

Alice_Yang — Fri, 12 Jul 2019 03:11:53 GMT

Hello 周周,

Please pay attention to the below tips:

1) "SDK debug console" choose "UART console":

2) Choose the right COM port on terminal. The PRINTF transfer through LPC-LINK USB port(J8) on board.

3) If still can't , try the Hello_world SDK demo , just connect board with J8 port, config as 1), then run it .

Hope it helps,

Have a great day,
TIC

-------------------------------------------------------------------------------
Note:
- If this post answers your question, please click the "Mark Correct" button. Thank you!

- We are following threads for 7 weeks after the last post, later replies are ignored
Please open a new thread and refer to the closed one, if you have a related question at a later point in time.
-------------------------------------------------------------------------------

LPC MicrocontrollersのトピックRe: About PRINT of .5.0_LPCXpresso54608

About PRINT of .5.0_LPCXpresso54608

Re: About PRINT of .5.0_LPCXpresso54608