Missing files when Using IR Sample code on LPC812MAX through Keil

chenyirock — Tue, 30 Oct 2018 09:16:48 GMT

Hi I download the IR remote controller/ receiver example form the following website.

https://www.nxp.com/products/processors-and-microcontrollers/arm-based-processors-and-mcus/lpc-cortex-m-mcus/lpc800-series-cortex-m0-plus-mcus/low-cost-microcontrollers-mcus-based-on-arm-cortex-m0-plus-cores:LPC81X_LPC83X?fpsp=1&tab=Documentation_Tab

I downloaded Keil version 5 to run the project which is version 4 project. Hence I downloaded the legacy support in order to open version 4 project in Keil as shown in the attached picture.

I think there should be more c and h files instead of just files related to GPIO. Like lpc8xx_mrt.c, lpc8xx_uart.c, lpc8xx_sct.c etc.

Could you help me on this? Thank you very much!

Re: Missing files when Using IR Sample code on LPC812MAX through Keil

kerryzhou — Wed, 31 Oct 2018 05:32:15 GMT

Hello Chen yi,

No, the project is correct, no files is missing.

If you check the AN11511_1.pdf, you will also find it is correct, please check this block diagram:

It use the SCT, gpio to realized it.

Wish it helps you!

Have a great day,
Kerry

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

topic Missing files when Using IR Sample code on LPC812MAX through Keil in LPC Microcontrollers

Missing files when Using IR Sample code on LPC812MAX through Keil

Re: Missing files when Using IR Sample code on LPC812MAX through Keil