LPC 1519 watchdog reset not happening correctly

ravalimuppalla — Mon, 13 Nov 2017 23:39:11 GMT

Hello,

I am trying to wake the Micro, 1519, from power down after WFI with a watchdog. I change the time in TC then put it to power down. So after TC amount of time i expect a reset from watchdog. But when i check the reset status it gives me a POR and not a watchdog reset.

LPC_WWDT->TC = 2 minutes; //previously the time was for 33sec

LPC_WWDT->MOD = 0x23;

disable_irq;

WFI;

enable_irq;

After reset i check the reset status with Chip_SYSCTL_GetSystemRSTStatus(); and i get a POR.

I tried "Chip_SYSCTL_EnableERP0PeriphWakeup(SYSCTL_ERP0_WAKEUP_WDTINT)" which wakes the micro but i don't get a reset on wake up, instead the micro waits for 90 seconds before getting reset. Then the reset status is watchdog reset.

Is there any reason for this?

Thanks!

Re: LPC 1519 watchdog reset not happening correctly

jeremyzhou — Wed, 15 Nov 2017 03:01:18 GMT

Hi Ravali Muppalla ,

Thank you for your interest in NXP Semiconductor products and 

for the opportunity to serve you.

To provide the fastest possible support, I'd like to recommend you to refer to the periph_wwdt demo in the LPCOpen library.

LPCOpen Software for LPC15XX|NXP

TIC

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

LPC MicrocontrollersのトピックLPC 1519 watchdog reset not happening correctly

LPC 1519 watchdog reset not happening correctly

Re: LPC 1519 watchdog reset not happening correctly