LPC Microcontrollers中的主题 LPC2103 ISP after software interrupt doesn't work

LPC2103 ISP after software interrupt doesn't work

bunny_stew — Tue, 05 Sep 2017 14:16:13 GMT

Hello,

I'm using the following code for software interrupt:

                VICIntSelect       = 0x00000000;
               VICIntEnClr           = 0xFFFFFFFF;
               VICSoftIntClr       = 0xFFFFFFFF;
               VICProtection       = 0x00000000;
               WDTC       = 0x32;
               WDMOD       = 0x03;
               WDFEED   = 0xAA;
               WDFEED   = 0x55;

After reset, I can't use my CP210x USB to UART bridge with Flash Magic tool. When I'm trying to flash LPC2103, Flash Magic tool always says: "Operation failed. Failed to autobaud Step 1". After I unplug the power cable of my controller and plug it again, Flash Magic tool works fine. Could someone help me, pls?

My LPC2103 settings:
CCLK = PCLK = 67.5Mhz
FOSC = 13.56 MHz.

Best regards,

Re: LPC2103 ISP after software interrupt doesn't work

CarlosCasillas — Fri, 08 Sep 2017 20:37:29 GMT

Hi Kim,

Have you ensured to avoid a ISR loop (properly clearing the flags)? If this happens, the processor will hang, and unable to proceed to other interrupts, and should be recovered just by a Power-On Reset.

You could also take a look at the following link for additional reference:

http://www.ocfreaks.com/lpc2148-interrupt-tutorial/

Hope this will be useful for you.
Best regards!
/Carlos
-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------