topic LPC 4370 custom design board in LPC Microcontrollers

LPC 4370 custom design board

sujayp — Mon, 19 Jun 2017 16:22:48 GMT

Dear NXP Technical Support Services,

I have a power supply board that supplies a Lpc4370 and other components of a system. When I measure the resistance between power and GND using a multimeter I get the following readings:

Between 3.3V and GND: 26 Ohms

The 3.3V and 1.2V rails have many decoupling caps around power supply pins of the LPc4370 microcontroller , are they the only cause for this much reduced isolation between these voltages and ground?

The system is running perfectly for couple of days , after running some trace unit testing , the system stops running with keil ulink pro and now i am using the Keil ulink 2 and it was showing swd commmunication failure.

I am using Keil MDK 5.23 version .

Actually the if you know it is from the hardware problem or firware version in keil it was displaying V2.03.

Regards
sujay

Re: LPC 4370 custom design board

jeremyzhou — Tue, 20 Jun 2017 01:34:38 GMT

Hi sujay p

Thank you for your interest in NXP Semiconductor products and

for the opportunity to serve you.

I also use the multimeter to detect the resistance between the GND and VCC: 2.2K Ohms in the LPC-link2, so I think it must be something with your board. whether you detected other boards which work well and I wonder the these values.

Have a great day,

TIC

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: LPC 4370 custom design board

sujayp — Thu, 22 Jun 2017 09:34:11 GMT

Hi,

The measurements are done when the system is powered OFF , when the power is on the resistance between the VCC and Ground get open circuit , For few days the programing the LPC4370FET256 it works fine , But i think I have run the bad firmware using the kiel ulink pro , May be in regarding the Code Read Protection [ CRP ].
now i am using the Keil ulink 2 may be due to that but it still was displaying the SWD communication failure.

Please will any one help in this regards.

Re: LPC 4370 custom design board

sujayp — Thu, 22 Jun 2017 12:24:27 GMT

Hi,

Maybe my latest programmed software has CRP enabled , If so how to delete the NXP Device LPC4370FET256 to re-enable the JTAG Device.