topic Re: How to set a fix IPv6 to Thread leader in Kinetis Software Development Kit

How to set a fix IPv6 to Thread leader

fabricetocci — Fri, 01 Sep 2017 16:52:17 GMT

Hi,

I want to set a fix IPv6 to the thread Leader.

How can I proceed?

Thank you.

Kind regards.

Re: How to set a fix IPv6 to Thread leader

stephanie_m — Tue, 12 Sep 2017 04:45:24 GMT

Hello,

You can use the $ifconfig command to configure the network just as it is shown in the following image.

If you want to do it in the code, you can do it by using the bind address function:

IP_IF_BindAddr6(ifHandle->ifUniqueId, &inIpAddr,ip6AddrTypeManual_c,

IP6_ADDRESS_LIFETIME_INFINITE, 64U);

Best Regards,

Estephania

Re: How to set a fix IPv6 to Thread leader

fabricetocci — Wed, 13 Sep 2017 06:55:34 GMT

Hi Estephania,

This is perfect.

Thank you!

Kind regards.

Fabrice

2017-09-12 6:46 GMT+02:00 estephania_martinez <admin@community.nxp.com>:

NXP Community
<https://community.freescale.com/resources/statics/1000/35400-NXP-Community-Email-banner-600x75.jpg>
Re: How to set a fix IPv6 to Thread leader
reply from Estephania Martinez Garcia
<https://community.nxp.com/people/estephania_martinez?et=watches.email.thread>
in Kinetis Software Development Kit - View the full discussion
<https://community.nxp.com/message/941925?commentID=941925&et=watches.email.thread#comment-941925>