fsl_ftm bug ?!

ahmedhrabi — Mon, 02 Jan 2017 15:17:34 GMT

Hi everyone,

I'am using the sdk 2.0 on a k64 board. I used the fsl_ftm driver for generating a pwm signal. Well for the FTM0 ch2 with a frequency of 100Khz everything works normal. But for a lower frequency (100hz) the pwm don't work and i don't get any output signal !

So i think that there's a bug in the fsl_ftm driver.

Even when i have updated the driver with this part of code everything goes wrong:

reg |= (FTM_CnSC_ELSA(chnlParams->level) | FTM_CnSC_ELSB(chnlParams->level));

Then we fixed it and changed to use the current one, which is corrected now.

            /* Setup the active level */
            reg |= (uint32_t)(chnlParams->level << FTM_CnSC_ELSA_SHIFT);

BR,

HR.A

Re: fsl_ftm bug ?!

xiangjun_rong — Tue, 03 Jan 2017 07:27:21 GMT

Hi, Ahmed,

Obviously, it is a bug. Because the line

reg |= (FTM_CnSC_ELSA(chnlParams->level) | FTM_CnSC_ELSB(chnlParams->level));

can set both ELSA/ELSB bits, or clear both ELSA/ELSB bits. It is impossible to set one bit and clear another bit, because the two macro use the same variable:

chnlParams->level

Xiangjun Rong

Kinetis Software Development KitのトピックRe: fsl_ftm bug ?!

fsl_ftm bug ?!

Re: fsl_ftm bug ?!