Kinetis Software Development Kit中的主题 Re: Hello World Demo will not compile / debug. Console reports: nothing to build

Hello World Demo will not compile / debug. Console reports: nothing to build

jimnelson — Fri, 22 Jul 2016 21:37:22 GMT

I recently purchased a FRDM-K22F board to develop some apps on.

I am new to Eclipse / GNU, so don't assume I know anything about it.

I downloaded Kinetis Design studio Version: 3.2.0 and installed it.

I downloaded and installed KSDK_1.3.0.

I installed the USB drivers, and the board is recognized - MBED drive shows.

I followed all instructions to the letter as near as I can tell.

As instructed, I imported the ksdk_platform_lib_K22F51212 - it appeared to build.

I next imported the hello_world_frdmk22f example - console says "Nothing to build for project hello_world_frdmk22f"

When I do debug-->debug configurations-->GDB OpenOCD Debugging-->hello_world_frdmk22f debug, I get an error:

"Missing mandatory configuration. Fill-in the 'Config options:' field in the Debugger tab"

I haven't a clue what I should fill in there though.

what's up with this? the demo should run as packaged right?

ivadorazinova — Mon, 25 Jul 2016 13:07:52 GMT

Hi Jim.

Thank you for your question.

Please, have you installed KSDK into KDS?

Please, do you have added -f kinetis.cfg in other options?

Please let me know, if this helps you.

Best Regards,

Iva

jimnelson — Mon, 25 Jul 2016 14:16:50 GMT

I confirmed that KSDK is installed in KDS

adding -f kinetis.cfg did not change the behavior.

The build console is still reporting:

**** Build of configuration debug for project hello_world_frdmk22f ****

Nothing to build for project hello_world_frdmk22f