Kinetis Software Development KitのトピックMQX RTOS SETUP in Kinetis SDK using processor expert

MQX RTOS SETUP in Kinetis SDK using processor expert

harshpatel — Mon, 03 Aug 2015 05:23:43 GMT

Hello

I am using Kinetis Design Studio 3.0.
KSDK 1.2.0 is installed.
MQX plug ins are also installed
I am trying to run "Hello world" MQX rtos code in Kitetis for FRDM K22F board.
i can create my own project and run it successfully without use of processor expert functionality....but..

now the problem is if i am trying to create new project using processor expert facility, i can build my code debug it but it will not work on Hardware.

i found following indication in console:

Reading all registers

Read 4 bytes @ address 0x00000410 (Data = 0x49124811)

Setting breakpoint @ address 0x00005750, Size = 2, BPHandle = 0x0001

Starting target CPU...

...Breakpoint reached @ address 0x00005750

Reading all registers

Removing breakpoint @ address 0x00005750, Size = 2

Read 4 bytes @ address 0x00005750 (Data = 0xF7FC4802)

Reading 64 bytes @ address 0x2000FFC0

Starting target CPU...

so please help me to solve this problem as fast as possible....

Re: MQX RTOS SETUP in Kinetis SDK using processor expert

ivadorazinova — Mon, 03 Aug 2015 08:54:13 GMT

Hello Harsh Patel,

please, what do you use for debugger?

If OpenSDA, please load J-Link and try it again.

You can follow these steps:

Segger J-Link Firmware for OpenSDAv2 | MCU on Eclipse

For loading J-Link do not forget to do:

1. Unplug the USB cable

2. Press and hold the Reset button.

3. Plug in a USB cable from a USB Host to the OpenSDAv2 USB port.

4. Release the RESET/Bootloader button.

5. A removable drive will be visible in the host file system with a volume label of BOOTLOADER

I hope this helps,

Iva

Re: MQX RTOS SETUP in Kinetis SDK using processor expert

harshpatel — Tue, 04 Aug 2015 09:13:39 GMT

Hi IVA Dorazinova

Thank you for reply...

I am using J-link and device also found in Com PORT. I can build project, Debug it using J link but if i RUN the code i found following notifications in Console ..

Reading all registers

Read 4 bytes @ address 0x00000410 (Data = 0x49124811)

Setting breakpoint @ address 0x00005750, Size = 2, BPHandle = 0x0001

Starting target CPU...

...Breakpoint reached @ address 0x00005750

Reading all registers

Removing breakpoint @ address 0x00005750, Size = 2

Read 4 bytes @ address 0x00005750 (Data = 0xF7FC4802)

Reading 64 bytes @ address 0x2000FFC0

Starting target CPU...

and than code will not further execute....

so what changes required?

Re: MQX RTOS SETUP in Kinetis SDK using processor expert

ivadorazinova — Wed, 05 Aug 2015 09:04:28 GMT

Hello Harsh Patel,

please, do you have the same issue as Unable to Debug after KDS Update and Unable to Debug after KDS Update ?

Thank you for your feedback!

Iva