topic Re: debug frdm-k82f in Kinetis Design Studio

debug frdm-k82f

mesdouaabderraz — Thu, 18 May 2017 09:37:49 GMT

hi i encounter a problem when i trail to debug a project withe frdm-k82f , any help please??

Re: debug frdm-k82f

harshpatel — Tue, 23 May 2017 08:00:39 GMT

Hello MESDOUA Abderrazek

Need some more detail to find issue but make sure following three things:

1] Enter your correct device name in debug configuration as shown in attachment

2] Make sure J-link and frdm board are 1 to 1 connected properly using Cable.

3] J link is Powered On properly

Let me know if any..

Regards

Harsh Patel

Re: debug frdm-k82f

Alice_Yang — Tue, 23 May 2017 08:33:57 GMT

Hello Mesdoua,

- Please update the firmware use the attachment "04_OpenSDA_FRDM-K82F.bin",

the steps as below :

1)Press the Reset button (and keep it pressed) while power the board with the OpenSDA USB connector(J5):.
2) The board will show up as BOOTLOADER drive on your system:
3) Copy"04_OpenSDA_FRDM-K82F.bin" to the BOOTLOADER driver:
4) The copy operation takes about 2-3 seconds, after finished , un power the board.
5) Power the board again normally .

- Then configure the debug view as Harsh Patel mentioned .

If still can't work, please take a video or screenshot to show your steps.

Hope it helps

Have a great day,
TIC

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: debug frdm-k82f

mesdouaabderraz — Tue, 23 May 2017 10:17:12 GMT

hi, thank you for your answer, i just have a question if it's possible please :

There is an example who can help me or a demo folder over uart connection?

because on my project i had buy a frdm-k82f nxp board and a Fingerprint Scanner GT-511C1R, and i want to connect they with uart port TX RX like on picture , for realise a test of Fingerprint recognition,

i know that i must write a code but my question is, There is an example who can help me or a demo folder on this topic?

Re: debug frdm-k82f

harshpatel — Wed, 24 May 2017 04:49:27 GMT

H‌ello MESDOUA Abderrazek

Nxp guys Alice_Yang can help in this issue.

Regards

Harsh Patel

Re: debug frdm-k82f

Alice_Yang — Fri, 26 May 2017 09:41:38 GMT

Hello Mesdoua,

About the UART example, you find in MCUXpresso SDK, about how to download please refer to :

https://community.nxp.com/docs/DOC-333304

Sorry I don't know the GT-511C1R clealy.

Alice