topic Re: KDS Plugin has not been registered in Kinetis Design Studio

KDS Plugin has not been registered

lifeng — Fri, 02 Jun 2017 11:03:04 GMT

The board is TWR-KE18F, MDK is normal, but in KDS, the system inform Plugin has not been registered. Order the register operation, input my email address , could not register . I had close the firewall .

Can't debug , can't download fash.

Re: KDS Plugin has not been registered

Alice_Yang — Mon, 05 Jun 2017 01:59:21 GMT

Hello Li feng,

- Please first check the Device Manager of PC, is there the OpenSDA driver?

- Please make sure there isn't another connect with your board .

- About the register , Please make your the network is well .

Alice

Re: KDS Plugin has not been registered

lifeng — Thu, 08 Jun 2017 07:15:31 GMT

After connect , PC recongised as mbed Serial Port(com5) . How to set it as OPENSDA?

In mdk, set Debug CMSIS-DAP Debugger, work normal, can bulid or download .

Re: KDS Plugin has not been registered

Alice_Yang — Thu, 08 Jun 2017 10:05:05 GMT

Hello Li,

Your board now is MBED firmware, please choose the "GDB OpenOCD debugging":

If it still can't work , please update the bootloader to Jlink or PEMicro.

Alice

Re: KDS Plugin has not been registered

lifeng — Fri, 09 Jun 2017 03:39:06 GMT

Hello Alice,

Now the debugger display is normal, but after debugger or flash download, informed missing a configuration.

Whitch is error?

Re: KDS Plugin has not been registered

Alice_Yang — Tue, 13 Jun 2017 09:15:10 GMT

Hello Li Feng,

Please configure the "Config options" as below :

Hope it helps

Have a great day,
TIC

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: KDS Plugin has not been registered

lifeng — Thu, 15 Jun 2017 00:20:31 GMT

Hello Alice,

After change config option, run debug, it says the mcu is unsupported.

But I can't find anywhere to change the mcu for import project, how to change it?

Re: KDS Plugin has not been registered

Alice_Yang — Thu, 15 Jun 2017 06:08:24 GMT

Hello Li Feng,

From the error message "MCU is unsupported" , it seems your device is not supported by OpenOCD, as OpenOCD needs to be implemented for your microcontroller. Have you tried P&E and Segger debug firmware on the board

already ? I recommend you test Segger debug firmware, the steps are as below :

1)Press the Reset button (and keep it pressed) while power the board withthe OpenSDA USB connector:.
2) The board will show up as BOOTLOADER drive on your system:
3) Copy"29_OpenSDA_TWR-KE18F.bin" to the BOOTLOADER driver:
4) The copy operation takes about 2-3 seconds, after finished , unpower the board.
5) Power the board again normally

Select the "GDB SEGGER J-Link debug" do download and debug :

Have a great day,
TIC

Re: KDS Plugin has not been registered

lifeng — Thu, 22 Jun 2017 08:03:42 GMT

Hello Alice,

Think you!

Now I still use MDK, no chanage firmware.

After complete the project, then to find how to use KDS.