topic Re: Error in Final Launch sequence in KDS with FRDM-K64F in Kinetis Design Studio

Error in Final Launch sequence in KDS with FRDM-K64F

gideshermann — Tue, 27 Sep 2016 14:52:55 GMT

Hello every on, i am trying to debug a project using KDS and FDM-K64F. After setting the debug parameters without problem, i then lunch the debug processe. it started well to flash the controller till a point i got the following error:

Thanks for any solution proposition.

Re: Error in Final Launch sequence in KDS with FRDM-K64F

Alice_Yang — Wed, 28 Sep 2016 02:07:44 GMT

Hello Gides,

Which debugger do you used ? Please show the debug configure view .

Also first test one simple project .

Alice

Re: Error in Final Launch sequence in KDS with FRDM-K64F

gideshermann — Wed, 28 Sep 2016 07:32:56 GMT

Hello Alice,

thanks for your reply. i Actually use the GDB OpenOCD Debugger. Yes i did already tried with another siple project and it works fine without problem.

you can see the debug config:

Thanks

Hermann

Re: Error in Final Launch sequence in KDS with FRDM-K64F

Alice_Yang — Wed, 28 Sep 2016 07:56:12 GMT

Hello Gides,

You said use the same configure , one simple project can work well ,while another one can not ,

so the problem is your project, not the debugger configure .

So please send your project to me , while in general , if one project can download , the other ones

should be also ok .

Alice

Re: Error in Final Launch sequence in KDS with FRDM-K64F

gideshermann — Wed, 28 Sep 2016 09:06:49 GMT

Hello Alice,

thanks for your help. I can't send you my project for some reasons.

You are right. the problem should be with the project files. i will try check on.

thanks again.

Hermann

Re: Error in Final Launch sequence in KDS with FRDM-K64F

Alice_Yang — Thu, 29 Sep 2016 06:44:45 GMT

Hello Gides,

-You can also submit a case to NXP support that only yourself and the service and support personnel can

see i :

https://community.nxp.com/docs/DOC-329745

- And you also can test he other debug method -jlink or PE debug .

Hope it helps

Alice

Re: Error in Final Launch sequence in KDS with FRDM-K64F

gideshermann — Thu, 29 Sep 2016 09:07:25 GMT

Hello Alice,

thanks very much for your support.

The problem has actually been figured out and solved.

One problem was that i had two microcontrollers pluged in on my pc, so one had to be plugged out.

And the second was about the memory mappin in my linker file. it has to be adjusted.

Now i can freely debug.

Thanks

Hermann