Kinetis Design StudioのトピックRe: KE15Z debug error (Error in service launch sequence)

KE15Z debug error (Error in service launch sequence)

jtpark — Wed, 14 Dec 2016 10:21:16 GMT

Hello,

I have tested KE15Z256xx on KDS 3.2 with my board but I can't debug mode.

When I checked debug configurations, I don't fine a KE15Z256xx device.

How can I debug to KE15Z256?

Is this device possible to develop by KDS?

Please let me know how to solve it.

Thanks.

Re: KE15Z debug error (Error in service launch sequence)

Alice_Yang — Thu, 15 Dec 2016 02:48:15 GMT

Hello J.K. ParK,

On my side, it have this chip:

So maybe you need install some update this is my Installation detail :

Frankly i can not be sure which update , maybe teh GUN ARM PEMicro Interface.. i mentioned above,

please compare mine with yours , then install the update as the steps:

If this update still can not work ,please install the others .

Hope it helps

Have a great day,
Alice Yang

-----------------------------------------------------------------------------------------------------------------------
Note: If this post answers your question, please click the Correct Answer button. Thank you!
-----------------------------------------------------------------------------------------------------------------------

Re: KE15Z debug error (Error in service launch sequence)

jtpark — Thu, 15 Dec 2016 04:48:22 GMT

Dear Alice,

Thank you for your reply.

I'm already installed.

But I can't fined KE15Zxx.

Would you please let me know how to solve this issue?

Thanks.

Re: KE15Z debug error (Error in service launch sequence)

Alice_Yang — Thu, 15 Dec 2016 07:54:35 GMT

Hello J.T. ParK,

Please install KSDK1.3:

Hope it helps

Have a great day,
Alice Yang

Re: KE15Z debug error (Error in service launch sequence)

jtpark — Thu, 15 Dec 2016 08:55:06 GMT

Dear Alice,

I have updated KSDK 1.3, but I can't solved this issue.

What can I check other update?

Thank you for your quickly reply.

I must solve this issue.

Please let me know how to solve it.